| Adjust the stack pack, lazy jacks lines, and reef lines |
| Coat stern extension drain holes with epoxy |
| Create and print watermaker logbook |
| Create and print watermaker procedure document |
| Cut, fit, and install foam blocks between battery banks |
| Flip the Reef 1/3 line |
| Glue weather stripping on bow lockers |
| Install anchor bridle |
| Install bowsprit hardware |
| Install forward lifelines |
| Install new stack pack |
| Mark the reef points on the Main halyard, Reef 1/3, and Reef 2 lines |
| Outboard lower unit bolt was found loose and water intrusion into the gear oil - drained gear oil, flushed with fresh gear oil, filled with Marvel Mystery Oil/Engine oil (ran 5 minutes) and drained, filled with Marvel Mystery Oil/Engine oil and drained, filled with lower unit gear oil |
| Polish stainless arch |
| Print out TIP and Mexican insurance paperwork and add to documentation binder |
| Remove rusted anchor bolts and install new bolts, grind down rust areas and coat with re-galvanizing paint |
| Remove solar panels to take pictures for warrant claim, file warranty claim, follow up on claim, and submit reimbursement paperwork |
| Remove stern stanchions after finding water inside the boat after heavy rain |
| Remove water mufflers, brackets and mounts - remove rust from all parts, paint brackets, and reattached brackets to mounts |
| Repair American flag post, reinforce flag post, and replace American flag |
| Repair stern extension damage (after drying with high air for two weeks) with a flox/epoxy mixture |
| Replace all seawater hose clamps with high strength stainless hose clamps (24 clamps) |
| Replace kayak rack bolts with longer bolts and relocate to the bottom the stanchions, Lanocote all parts |
| Replace line used to lift the doors |
| Replace missing screws on the screecher Furler block bracket |
| Replace seawater hose on starboard head from water pump to the head |
| Replace seawater hoses (6) from heat exchanger to anti-siphon valve to exhaust elbow hoses and replace 5/8" hose to 3/4" hose plastic adapter with brass parts |
| Replace upper tool cabinet latch |
| Replace weatherstripping on SB cockpit locker and mast locker |
| Sand rust on engine air filter cases, paint with rust converting paint, and reinstall |
| Sand/grind rust on the engines, paint with primer, paint with Yanmar touch up paint |
| Solar panel corrosion treatment - remove, wire brush corrosion, aluminum corrosion treatment jelly, wash, coat with enamel paint, apply 3m 4000UV to frame/glass joint |
| Treat corrosion on saloon window latches and paint black |
| Treat stanchions and deck for rust stains |
| Wash dinghy |
| Wash lines |
No Comments