December 4, 2020
Before getting to the excitement of the day there was a setback. When placing the Vertical Stabilizer on the airframe it became apparent that my VOR/GS antenna install was for shit. It would interfere with the rudder, fuck me. So rivets drilled, parts removed, doubler and nutplates flipped, and slots cut for the antenna to slide down the VS skins.…
November 10, 2020
With three of us working I bounced around a bit but my main focus was finishing the Vertical Stabilizer. I had some rivets on the rear spar before I could assemble and start the not so fun riveting which involved reaching way up inside the cavity for a number of hours. I also helped with the fuel valve/lines installation only…
November 9, 2020
Finished up the deburring of the holes, counter sinking spar holes, cleaning the parts, and finally priming them. Cue the riveting, today I seemed to not have my head on straight. Half the rivets had to be drilled out either due to incorrect assembly or crappy rivet setting. Ugh, one of those day. But I did get the rear spar…
November 8, 2020
Well almost, first I had to build a new stand for the wings for the install of the ER fuel tanks. The current stand supports the wings from the ends which obviously won’t work when sliding a tank on the outboard side. A couple hours later I feel good about the stability of what I built. Then the final bit…
October 30, 2020
Headed to see my parents in the afternoon so it was short day. I was able finish mounting the Rami Nav antenna to the top of Vertical Stabilizer after starting the fabrication of the doubler yesterday. Also on the Wing front – got the pitot mast prep’d and primed. Right wing skin is primed.