February 13, 2021
I bit the bullet and sanded the windshield surround fiberglass. That was a three hour project, but it looks pretty good and will certainly keep the windshield from departing the aircraft. Whew, happy to have that checked off. Then it was time for more sanding, this time sanding on the co-pilot door sill I epoxied yesterday. It turned out well,…
February 8, 2021
Guess what. I started the day with sanding. Knocked out of outside of both doors and lots of sanding on the windshield. Hours upon hours of bliss. Later in the day I put on, what I hope is the final fiberglass layer on the windshield. After sanding I’ll make a final determination. The big excitement for the day was getting…
February 4, 2021
I feel good about today, only because of what I got accomplished. It started with two and a half hours prep’ing windows and sanding the windshield. Still more sanding on the fiberglass tomorrow but I couldn’t take any more. I moved on to the poorly built Hotel Whiskey ER fuel tanks. Troy at Hotel Whiskey warranties them for life and…
February 3, 2021
Yep, still taping/sanding windows. I got the rear windows finished on the inside and I got some prep work done on the windshield on the inside. Put down another layer of fiberglass around the windshield on the outside. Of course this meant more sanding first. Have I mentioned how much I enjoy sanding? The replacement ER Fuel tanks arrived today.…
February 2, 2021
Wow baby, that was a bigger pain than one would think. Lots of nutplates – check. Metal forming – check, minimal room for riveting – fucking check. Only had to drill out two nutplates that interfered with the rivets to the fuselage, that would have been nice to note in the manual. Yep, I’m a little salty. Still remaining is…
January 31, 2021
Oh I’m sure something will pop up but this morning I finished the wiring behind the panel and was happy to see the autopilot servos were detected, firmware automatically updated, and the looked good. I may have accidentally run the aux fuel tank pumps for a second, so I know those work too. I still need to wire the wing…
January 30, 2021
Ugh, I am tired of wiring but there is still work to be done. Hopefully tomorrow I can finish up the avionics/electrical. Notice no pictures, yeah it pretty much looks the same as before I started. Yes I am salty. But as a break from wiring, the flaps are now on and connected to the flap tube. That means time…
January 30, 2021
Whew, this was a big day. A number of smaller items checked off and a couple big ones too. First up was installing the new servo motor in the rear vent. Back when I wired it up, no workie. So AeroSport sent a new servo and that did the trick. Took some time to get the mechanical and electronic settings…
January 28, 2021
Guess who started the day with sanding? And who finished the day with sanding? This guy. But the sun visor blocks are installed and the flox/micro turned out well. From there it was on to the cowling which needed nutplates installed and since we were on nutplates, why not install them on the spinner bulkheads. I still have all the…
January 27, 2021
The ignition cables are now better organized with spacers between to ensure no cross firing. Got the screws installed in the tail fairing, which turned into more work than I expected. Well there were two nutplates involved… Before the window installed I needed to get the sunvisors mounted. With the doors on I could find the best location and then…